Table of Contents
Advertisement
Restarting the Run Flat Indicator
The tire inflation pressure monitor must be
restarted in the following situations:
If you have changed the tire inflation
pressure
If you have replaced the wheels or tires
If you have installed new wheels or
tires
Using the Tire and Loading Information
placard on the driver's door B-pillar or,
if available, the tire inflation pressure
label on the inside of the fuel filler flap,
make sure the tire inflation pressure of
all four tires is correct.
Warning!
The Run Flat Indicator can only warn you in
a reliable manner if you have set the correct
tire inflation pressures for each tire.
If an incorrect tire inflation pressure was
set, the system will monitor the pressure
according to the incorrect value.
Switch on the ignition ( page 38).
Make sure the standard display menu
appears in the multifunction display
( page 147).
Press button k or j repeatedly
until the following message appears in
the multifunction display:
Press the reset button in the
instrument cluster ( page 138).
The following message will appear in
G
the multifunction display:
Restart
Run Flat Indicator?
Cancel
Yes
Tires and wheels
If you wish to confirm activation:
Press button æ.
The following message will appear in
the multifunction display:
Run Flat Indicator
Restarted
After a certain "learning phase", the Run
Flat Indicator checks the set pressure val-
ues for all four tires.
If you wish to cancel activation:
Press button ç.
or
Wait until the message
Restart
Run Flat Indicator?
Cancel
Yes
disappears.
Operation
343
Advertisement
Table of Contents
