Mercedes-Benz 2008 C-Class Operator's Manual page 446

Guide the Minispare wheel onto the
wheel hub and push it on.
Insert wheel bolts and tighten them
slightly.
Lowering the vehicle
Lower vehicle by turning crank
counterclockwise until vehicle is
resting fully on its own weight.
Remove the jack.
1 - 5 Wheel bolts
6 Wheel wrench
Practical hints
Tighten the five wheel bolts evenly,
following the diagonal sequence
illustrated (1 to 5), until all bolts are
tight. Observe a tightening torque of
96 lb-ft (130 Nm).
Warning!
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
96 lb-ft (130 Nm).
Before storing the jack, it should be fully
collapsed, with handle folded in (storage
position).
Store the jack and the other vehicle
tools in the designated storage space
underneath the trunk floor
( page 420).
i
Vehicles with TPMS (USA only):
Do not activate the tire inflation pressure
monitor ( page 344) until a full size wheel/tire
with functioning sensor has been placed back
into service on the vehicle.
Flat tire
G
445