Mercedes-Benz 2008 C-Class Operator's Manual page 173

Controls in detail
Control system
Depending on the previous status, the
daytime running lamps feature will be
Enabled or Disabled .
With Daytime Running Lamps
abled selected and the exterior lamp
switch at position M or *, the low
beam headlamps are switched on when
the engine is running.
In low ambient light conditions the follow-
ing lamps will switch on additionally:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
also illuminates the instrument cluster.
For more information on the daytime run-
ning lamp mode ( page 110).
i
If you turn the exterior lamp switch to anoth-
er position, the corresponding lamp(s) will
switch on.
172
i
Make sure the light switch is set to B
or * when you switch off the daytime running
lamps while driving at night.
i
mode En-
For safety reasons, resetting the Lights
submenu to factory settings ( page 165) while
driving will not deactivate the daytime running
lamp mode.
The following message appears in the
multifunction display:
Lighting - Cannot be completely reset
to factory settings while driving.
Setting locator lighting
Press % or $ to select the
Lights submenu.
Press #.
Press % or $ to select the
round Lighting
Press #.
The current setting
or Disabled
Sur-
feature.
Enabled
is shown.
Press # again if you would like to
change the current status.
Depending on the previous status, the
locator lighting feature will be
or Disabled .
With the locator lighting feature activated
and the exterior lamp switch in
position U, the following lamps will
switch on during darkness when the vehi-
cle is unlocked with the SmartKey:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
Front fog lamps
also illuminates the instrument cluster.
Enabled