Engine Oil Adding - Mercedes-Benz 2012 E-Class Sedan Operator's Manual

Engine compartment
310
Example: vehicles with a diesel engine
X
Park the vehicle on a level surface.
To check the oil level with the engine at
operating temperature, switch the engine
off and wait for approximately five minutes.
X
Pull oil dipstick : out of the dipstick guide
tube.
X
Wipe off oil dipstick :.
X
Slowly slide oil dipstick : into the guide
tube to the stop, and take it out again.
If the level is between MIN mark = and
MAX mark ;, the oil level is correct.
X
If the fuel level has sunk to MIN mark = or
below, add 0.55 to 1.1 US qt (0.5 to 1.0 l)
engine oil.
Adding engine oil
G
WARNING
If engine oil comes into contact with hot
engine parts, it may ignite and you could burn
yourself. Do not spill any engine oil on hot
engine parts.
H
Environmental note
When adding oil, take care not to spill any. If
oil enters the soil or waterways, it is harmful
to the environment.
! Use only engine oils and oil filters that
have been approved for vehicles equipped
with a service system. A list of the engine
oils and oil filters tested and approved in
accordance with the Mercedes-Benz
Specifications for Service Products can be
called up by visiting http://
www.mbusa.com (USA only). More
information about tested and approved
engine oils and oil filters is available from
any authorized Mercedes-Benz Center.
Damage to the engine or exhaust system is
caused by the following:
using engine oils and oil filters which
R
have not been specifically approved for
the service system.
replacing the engine oil or oil filter after
R
the replacement interval required by the
service system has elapsed
using engine oil additives.
R
! Do not add too much oil. If the oil level is
above the "max" mark on the dipstick, too
much oil has been added. This can lead to
damage to the engine or the catalytic
converter. Have excess oil siphoned off.
Example: engine oil cap
X
Turn cap : counterclockwise and remove
it.
X
Add engine oil.
If the oil level is at or below the MIN mark
on the oil dipstick,
add 0.55 to 1.1 US qt (0.5 to 1.0 l) engine
oil.
X
Replace cap : on the filler neck and turn
clockwise.
Ensure that the cap locks into place
securely.
X
Check the oil level again with the oil
Y
dipstick ( page 309).
I n f o r m a t i o n P r o v i d e d b y :