Table of Contents
Advertisement
Keeping jack in this position, turn
crank 3 clockwise until the jack base
meets the ground. Make sure the jack
is vertical (plumb line).
Continue to turn the crank until the tire
is a maximum of 1.2 in (3 cm) from the
ground.
Removing the wheel
1 Alignment bolt
Unscrew upper-most wheel bolt and re-
move.
Replace this wheel bolt with alignment
bolt 1 supplied in the tool kit.
Remove the remaining bolts.
!
Do not place wheel bolts in sand or dirt. This
could result in damage to the bolt and wheel hub
threads.
Remove the wheel.
Practical hints
Mounting the new wheel
Warning!
Inflate spare wheel tire only after the wheel
is properly mounted.
Inflate the spare wheel tire using the electric
pump ( page 410) before lowering the ve-
hicle.
Clean contact surfaces of wheel and
wheel hub.
Guide the spare wheel onto the align-
ment bolt and push it on.
Insert wheel bolts and tighten them
slightly.
Flat tire
G
409
Advertisement
Table of Contents
