Table of Contents
Advertisement
Operation
Engine compartment
Coolant
Warning!
In order to avoid any possibly serious burns:
Use extreme caution when opening the
hood if there are any signs of steam or
coolant leaking from the cooling system,
or if the coolant temperature gauge indi-
cates that the coolant is overheated.
Do not remove pressure cap on coolant
reservoir if coolant temperature is
above 158°F (70°C). Allow engine to
cool down before removing cap. The
coolant reservoir contains hot fluid and
is under pressure.
Using a rag, slowly open the cap approx-
1
imately
/
turn to relieve excess pres-
2
sure. If opened immediately, scalding
hot fluid and steam will be blown out un-
der pressure.
Do not spill antifreeze on hot engine
parts. Antifreeze contains ethylene gly-
col which may burn if it comes into con-
tact with hot engine parts.
280
The engine coolant is a mixture of water
and anticorrosion/antifreeze. To check
the coolant level, the vehicle must be
G
parked on level ground and the engine
must be cool.
The coolant expansion tank is located on
the passenger side of the engine compart-
ment.
1 Coolant expansion tank
Using a rag, slowly turn the cap approx-
imately one half turn counterclockwise
to release any excess pressure.
Continue turning the cap counterclock-
wise and remove it.
The coolant level is correct if the level
for cold coolant: is up to the upper
mark on the bracing rib of the coolant
expansion tank (translucent)
for warm coolant: is approx. 0.6 in
(1.5 cm) higher
Add coolant as required.
Replace and tighten cap.
!
SL 600 and SL 65 AMG: Only open the cap
on coolant expansion tank 1. Never open the
cap between the two charge-air coolers. Other-
wise, the engine could be damaged.
For more information, see "Coolants"
( page 449).
Advertisement
Table of Contents
