Maintenance; Line Button - Pioneer X-HM20V-s Operation Manual

Troubleshooting chart (continued)
n HDMI
Symptom
No picture.
l l
l
l
l
n Condensation
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet (CD pickup, etc.) or on the transmitter
on the remote control. Condensation can cause the unit to
malfunction. If this happens, leave the power on with no
disc in the unit until normal playback is possible (about 1
hour). Wipe off any condensation on the transmitter with a
soft cloth before operating the unit.
n If problem occurs
When this product is subjected to strong external
interference (mechanical shock, excessive static
electricity, abnormal supply voltage due to lightning, etc.)
or if it is operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1 Set the unit to the stand-by mode and turn the power on
again.
2 If the unit is not restored in the previous operation,
unplug and plug in the unit again, and then turn the
power on.
Note:
If neither operation above restores the unit, clear all the
memory by resetting it.
Possible cause
Video signals that are input
from the analog video terminal
will not output from the HDMI
terminal. Signals that are input
from the HDMI terminal will not
output from the analog video
terminal. Be consistent with
the type of cable between
input and output.
This receiver is HDCP-
compatible. Check that the TV
you are connecting are also
HDCP-compatible. If they are
not, please connect them
using the component or
composite video jacks.
If video images do not appear
on your TV, try adjusting the
resolution, Deep Color or other
setting for your component.
To output signals in Deep
Color, use an HDMI cable
®
(High Speed HDMI Cable) to
connect this receiver to TV
with the Deep Color feature.
n Factory reset, clearing all memory
For DISC/USB Video function:
Please refer "Changing the Setup Menu" on page 13.
Select "PREFERENCE", "DEFAULT" and then "RESET".
For others function:
1 Press the STANDBY/ON button to turn the power on.
2 Press the LINE button on the remote control or INPUT
button repeatedly on the main unit to select LINE IN
function.
3 In LINE IN function, press the
main unit press and hold the
appears.
Caution:
This operation will erase all data stored in memory
including clock, timer settings, tuner preset.
n Before transporting the unit
Remove the iPod, USB memory device and disc from the
unit. Then, set the unit to the power stand-by mode.
Carrying the unit with iPod or USB memory device left
docked or discs left inside might damage the unit.
n Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the
l
non-label side from which signals are read. Do not
mark this surface.
Keep your discs away from direct sunlight, heat, and
l
excessive moisture.
Always hold the CDs by the edges. Fingerprints, dirt, or
l
water on the CDs can cause noise or mistracking. If a
CD is dirty or does not play properly, clean it with a soft,
dry cloth, wiping straight out from the centre, along the
radius.
NO

Maintenance

n Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thinner,
l
etc.). It may damage the cabinet.
Do not apply oil to the inside of the unit. It may cause
l
malfunctions.
En-40
button on the
button until "RESET"
YES
Correct