Advertisement
Follow the procedures below to install a 3.5" floppy disk drive on the
top tray:
1. Fasten one pair of mounting brackets to both sides of a 3.5" floppy
disk drive. Note that the guide edge of the mounting brackets
should be at the lower side.
2. Open the door of the device bay. Unfasten and remove the top
cover plate of the device tray.
3. Insert the floppy disk drive with attached mounting brackets into
the device tray.
4. Fasten the mounting brackets to the device bay.
5. Open the back cover of the chassis, and connect the cables from
the installed device to the backplane of the MIC-3021/8.
6. Close the back cover.
Advertisement
