Table of Contents
Advertisement
Checking engine oil level with the
control system
When checking the oil level
the vehicle must be parked on level
ground
with the engine at operating tempera-
ture, the vehicle must have been
stationary for at least 5 minutes with
the engine turned off
with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the multi-
function display, do the following:
Switch on the ignition ( page 36).
The standard display ( page 147) should
appear in the multifunction display.
Press button k or j, on the
multifunction steering wheel until the
following message is seen in the multi-
function display:
One of the following messages will
subsequently appear in the multifunc-
tion display:
Engine oil level ok
Add 1.0 Qt.
to reach max. oil level
(Canada:
)
1.0 Liter
Add 1.5 Qts.
to reach max. oil level
max. oil level
(Canada:
1.5 Liters
)
Add 2.0 Qts.
to reach max. oil level
max. oil level
(Canada:
2.0 Liters
)
Engine compartment
i
If you want to interrupt the checking
procedure, press the k or j
button on the multifunction steering
wheel.
If necessary, add engine oil.
For adding engine oil, see ( page 296).
For more information on engine oil, see the
"Technical data" section ( page 461) and
( page 464).
Other display messages
If the SmartKey or KEYLESS-GO start/stop
button* is not in position 2, the following
to reach
message will appear:
Switch on ignition
to check engine oil level
Switch on the ignition ( page 36).
to reach
If you see the message:
Observe waiting period
Operation
295
Advertisement
Table of Contents
