Mercedes-Benz 2005 E -Class Wagon Operator's Manual page 302

Checking engine oil level with the
control system
When checking the oil level
the vehicle must be parked on level
ground
with the engine at operating tempera-
ture, the vehicle must have been sta-
tionary for at least five minutes with the
engine turned off
with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the multi-
function display, do the following:
Switch on the ignition ( page 34).
The standard display ( page 153) should
appear in the multifunction display.
Press button k or j, on the
steering wheel until the following
message is seen in the multifunction
display:
Engine oil level - Measuring now!
Measurement correct only if veh.
level
One of the following messages will
subsequently appear in the indicator:
Engine oil level ok
Add 1.0 Qt. to reach max. oil
level
(Canada: 1.0 Liter )
Add 1.5 Qts. to reach max. oil
level
(Canada: 1.5 Liters )
Add 2.0 Qts. to reach max. oil
level
(Canada: 2.0 Liters )
Engine compartment
i
If you want to interrupt the checking
procedure, press the k or j
button on the multifunction steering
wheel.
If necessary, add engine oil.
For adding engine oil, see ( page 302).
More information on engine oil can be
found in the "Technical data" section
( page 450) and ( page 453).
Other display messages
If the SmartKey or KEYLESS-GO start/stop
button* is not in position 2, the following
message will appear:
Switch on ignition
to check engine oil level
Switch on the ignition ( page 34).
Operation
301