Mercedes-Benz 2005 E -Class Wagon Operator's Manual page 283

Controls in detail
Useful features
Operation of integrated remote control
Switch on the ignition ( page 34).
Select and press the appropriate inte-
grated signal transmitter button (1,
2 or 3) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
Switch on the ignition ( page 34).
Simultaneously hold down the signal
transmitter buttons 1 and 3, for ap-
proximately 20 seconds, until the indi-
cator lamp 4 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.
282
i
If you sell your vehicle, erase the codes
of all three channels.
Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Press and hold the desired signal trans-
mitter button (1, 2 or 3). Do not re-
lease the button.
The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.