Table of Contents
Advertisement
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
i
This function is not available in
countries where the daytime running
lamp mode is mandatory and therefore
in a constant mode.
Move the selection marker with
button æ or ç to the
submenu.
Press button j or k repeatedly
until the message
Lamp circuit
headlamp
appears in the multifunction
display.
The selection marker is on the current
setting.
152
Press button æ or ç to select
manual operation (
running lamp mode (
ed.
Lighting
With daytime running lamp mode activated
and the exterior lamp switch in
position M or U the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
For more information on the daytime run-
ning lamp mode, see "Lighting"
( page 122).
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
manual
) or daytime
For safety reasons, resetting the
constant
) activat-
Lighting
( page 143) while driving will not
deactivate the daytime running lamp
mode.
The following message appears in the
multifunction display:
Lighting – Cannot be completely
reset to factory settings while
driving
submenu to factory settings
.
Advertisement
Table of Contents
