Direct Paging - Handsfree Answerback Disabled - Mitel 5360 User Manual

Direct Paging - Handsfree Answerback Disabled

Your administrator enables or disables Handsfree Answerback and you can also turn it on or
off on your phone. To turn Handsfree Answerback off, see "Direct Paging - Handsfree
Answerback Enabled" elsewhere in this guide. When Handsfree Answerback is disabled on
your phone and you receive a Direct Page, the Direct Page is indicated by a single burst of
tone.
To answer Direct Page calls when Handsfree Answerback is disabled:
Phone state before Page
arrives:
Phone is idle and MUTE is OFF.
You are on a handset call or
headset call, and MUTE is OFF
You are on a MUTED handset/headset
call, OR, you are on a Handsfree call
To end a Direct Page call, do one of the following:
Hang up the handset to end a handset call.
x
Press (SPEAKER) to end a Handsfree call.
x
Press (CANCEL).
x
When the Handsfree Direct Page call ends, the (MUTE) key light returns to the state it was in
before the call was established.
To answer the Direct Page
(indicated by single burst of tone):
1. Check that MUTE is ON solid.
2. Lift the handset OR press the MUTE key to answer in
Handsfree mode. (The light turns OFF.)
3. Begin speaking.
1. Check that MUTE is flashing.
2. Press MUTE. The light turns ON solid and you are now
speaking to the paging party and have MUTED your
handset/headset call.
3. Speak to the paging party. Press MUTE to alternate
between handset and handsfree calls.
The party paging you receives a busy tone. Handsfree
Answerback does not interrupt your call.
- 52 -