Rims And Tyres - BMW F 800 GT Rider's Manual

Adjusting clutch play
8
96
Move the rubber grommet 1 to
one side.
Slacken nut 2.
z
To increase clutch play: screw
the adjusting screw 3 into the
manual valve.
To reduce clutch play: un-
screw the adjusting screw 3
from the manual valve.
Checking the clutch play
( 95).
Tighten nut 2 while holding the
adjusting screw 3 in position.
Fasten the rubber grommet 1
over the nut.

Rims and tyres

Checking rims
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Visually inspect the rims for
defects.
Have any damaged rims in-
spected by a specialist work-
shop and replaced if neces-
sary, preferably by an author-
ised BMW Motorrad dealer.
Check the tyre tread
depth
WARNING
Riding with badly worn tyres
Risk of accident due to impaired
handling
If applicable, have the tyres
changed in good time before
they wear to the minimum
tread depth permitted by law.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Measure the tyre tread depth
in the main tread grooves with
wear marks.
NOTICE
Wear indicators are built into the
main profile grooves on each
tyre. The tyre is worn out when
the tyre tread has worn down
to the level of the marks. The
locations of the marks are indic-
ated on the edge of the tyre, e.g.
by the letters TI, TWI or by an
arrow.
If the tyre tread is worn to min-
imum:
Replace tyre or tyres, as applic-
able.