handle of the stand back until
both rollers of the stand are on
the ground.
Then press the handle down to
the ground.
Bulbs
Replacing low-beam and/
or high-beam headlight
bulb
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove cover 1 for the high-
beam headlight or cover 2 for
the low-beam headlight as ap-
plicable, by pulling lever 3.
NOTICE
The positions of the plug, the
spring wire retainer and the
bulb might not be as illustrated
below.
Disconnect plug 1.
Disengage spring wire clips 1
from the fastenings and swing
them aside.
Remove bulb 2.
8
105
z