BMW F 800 GT Rider's Manual page 65

Within ten seconds, switch on
the ignition.
Acknowledgement tone sounds
three times.
The programming function is
active.
Programming is a four-step pro-
cess, although no function is al-
located to step 2. The number of
times the anti-theft alarm LED on
the vehicle flashes corresponds
to the active programming step.
An alarm tone sounds by way of
confirmation when button 1 is
pressed, and an acknowledge-
ment tone sounds when button 2
is pressed.
Step 1: Do you want a con-
firmation tone to sound after
activation/deactivation of the
anti-theft alarm?
Yes:
Press button 1.
No:
Press button 2.
Step 2:
No function allocated to this step.
Press button 1 or button 2.
Step 3: Which alarm tone
would you like the alarm to
sound?
Rising and falling:
Press button 1.
intermittent:
Press button 2.
Step 4: Do you want to have
the alarm function activated
automatically when you switch
off the ignition?
Yes:
Press button 1.
No:
Press button 2.
Under what
circumstances is
programming aborted?
There are two ways in which pro-
gramming can be cancelled:
if the ignition is switched off
before completion of the last
step in the programming se-
quence.
automatically if more than
30 seconds are allowed to
elapse between any two
consecutive steps in the
programming routine.
The new settings are not saved if
programming is aborted.
Saving programming
There are two ways in which pro-
gramming can be saved:
if the ignition is switched off
after completion of the last
step in the programming se-
quence
5
63
z