Download Print this page

Braun 7680 Instructions Manual

Syncro system smart logic
Hide thumbs

Advertisement

7680
+
Type 5491

Advertisement

loading

  Related Manuals for Braun 7680

  Summary of Contents for Braun 7680

  • Page 1 7680 Type 5491...
  • Page 2 Internet: www.braun.com 5-491-391/00/XI-02/G2 KOR/GB Printed in Germany...
  • Page 3 Syncro 7680 Clean &Charge No. 7000...
  • Page 4 +35°C +15°C...
  • Page 7 Syncro 7000 7000...
  • Page 13 A Shaver Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver. Your Braun Syncro is supplied with a Braun Clean&Charge (please see section B). SmartLogic Inside The «SmartLogic» electronics inside your shaver analyzes...
  • Page 14 Display The pilot light shows that the shaver is connected to the mains. The display shows the operation mode and charging status of the shaver: During charging, the display shows the battery capacity symbol increasing by 20% segments and the charging time remaining (flashing): First charging (4 h): The display counts down in 20 min.
  • Page 15 The SmartLogic inside your shaver will detect when the shaver needs to be cleaned (refer to paragraph «Manual cleaning» or to separate «Clean&Charge» use instructions). To reset the display, push the info key. The SmartLogic inside will recognize when the shaver has to be lubricated (refer to paragraph «Manual cleaning»...
  • Page 16 Using the brush, clean the cutter block and the inner area of the pivoting head. About every four weeks, clean the cutter block with Braun cleaning agents. If your skin is very dry and you notice a reduced operation time of the shaver or if the display shows «oil!», apply a...
  • Page 17 Environmental notice This appliance is provided with nickel-hydride recharge- able batteries. To protect the environment, do not dis- pose of the appliance in the household waste at the end of its useful life. Open the housing as shown, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations.
  • Page 18 B Clean&Charge Braun Clean&Charge has been developed for cleaning, charging and storing your shaver. Clean your shaver daily in the Clean&Charge. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver.
  • Page 19 Technical specifications • Power consumption: • 3 W when cleaning • 7 W when charging • Power supply: 100 -240 V 2/ 50 or 60 Hz (automatic adaptation) • Input voltage: 12 V Before using Clean&Charge Only applies for cordless shavers: For the first charge of the shaver, connect the low voltage supply cord directly to the shaver, charge it for 4 hours and shave at least once.
  • Page 20 • «charge» (about 60 min) • The corresponding lights will come on. • (With cord shavers, only the «clean» function can be selected.) • Slide down the contact bow to connect the shaver and to start the selected programme. • If no programme is selected, the default function «clean» will be started.
  • Page 21 This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance.