A Shaver Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver. Your Braun Syncro is supplied with a Braun Clean&Charge (please see section B) SmartLogic Inside The «SmartLogic» electronics inside your shaver analyzes your personal shaving patterns, and then adapts the battery care to ensure optimal performance.
• A full charge will give up to 50 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles. • Best environmental temperature range for charging is 15 °C to 35 °C.
Page 14
Keeping your shaver in top shape Automated cleaning The Braun Clean&Charge takes care of all cleaning and lubrication needs of your shaver. Please refer to section B. Manual cleaning For easy cleaning after each shave, switch the shaver off.
18 months and get a 25% better shave.* (Shaver foil and cutter block: part no. 7000. Available at your dealer or Braun Service Centres.) (* Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months.) Environmental notice This appliance is provided with nickel-hydride recharge- able batteries.
Page 16
B Clean&Charge Braun Clean&Charge has been developed for cleaning, charging and storing your shaver. Clean your shaver daily in the Clean&Charge. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver.
Page 17
Technical specifications • Power consumption: • 3 W when cleaning • 7 W when charging • Power supply: 100 -240 V 2/ 50 or 60 Hz (automatic adaptation) • Input voltage: 12 V Before using Clean&Charge Only applies for cordless shavers: For the first charge of the shaver, connect the low voltage supply cord directly to the shaver, charge it for 4 hours and shave at least once.
Page 18
Operating your Clean&Charge • Connect your Clean&Charge with the low voltage supply cord to the mains electricity supply. • Open the contact bow (13) by pressing the release button (14). After shaving, switch the shaver off and place it upside down into the Clean&Charge (without having released the shaver foil).
Page 19
This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance.