Ir Outputs; All Ir Output - Elan SS1 Installation Manual

SS1 System Station

IR Outputs

The programmable IR Outputs are typically used to control Audio/Video sources using IR.
Connect single or dual IR emitters from the SS1 System Station to the devices to be con-
trolled. Make sure to pay close attention to which ports are connected to which sources for
IR routing purposes. There are twelve source-specific IR ports on each SS1 System Station.

ALL IR Output

Any IR signal sent into the SS1 will come out the ALL port. Use this for non-identical IR
sources and for sources that need to be controlled regardless of what source is actually
selected (A/V receiver or TV, for example).
Page 44
INSTALLATION MANUAL
SS1
IR OUTPUTS
1 2 3
7 8 9
IRE2 Talk-Back Emitter
IRE2 Talk-Back Emitter
IRE2 Talk-Back Emitter
Figure 4.23 - IR Output Connections-No PSS1
SS1
Quad to
Mono 3.5mm
Interconnect
ALL IR OUTPUT
Cable
(supplied w/ IRD4)*
EXT IR INPUT
*Use ONLY
Supplied Quad to
Mono 3.5mm
Interconnect Cable
Figure 4.24 - IR Output Connections-No PSS1
E L A N H O M E S Y S T E M S
4 5 6
10 11 12
IR Sources
IRD4
Amplified Connection Block
IRE1 IR Emitter
EM ON
BL ON
EM ON BL ON
NET OFF NET ON
IRD4 Amplified
Connecting Block
© ELAN Home Systems 2007 • All rights reserved.
IR Sources
IRE1 IR Emitter
IRE1 IR Emitter