Connections When Not Using A Pss1 Precision Panel; Relay 1-8; Via!Net/Znet - Elan SS1 Installation Manual

SS1 System Station

Connections When Not Using a PSS1 Precision Panel

It is possible to make connections for the SS1 System Station without the use of a PSS1
Precision Panel. This section describes these connections.
NOTE: The use of a PSS1 Precision Panel is HIGHLY RECOMMENDED!

Relay 1-8

The SS1 System Station provides eight closed-contact relays that can be programmed with
VIA!TOOLS to provide automated events such as lift operation, screen operation, and drap-
eries. Connections include PWR, GND, NC, COM, and NO.

VIA!NET/ZNET

Use a Cat-5 wire with ELAN Standard RJ-45 pinout to connect the SS1 System Station to a
system's VIA!NET and ZNET when installing ELAN devices including S6, S12, and Z•630
Multi-Room Controllers and SC-4 System Controllers.
NOTE: Use of system-specific Precision Panels for S and VIA! is required for proper func-
tionality when integrating serial controlled devices with the SS1 System Station.
Page 40
INSTALLATION MANUAL
Normally Open
SS1
Relay Controlled Device
External Voltage
+0-24 Volt
AC or DC
Power
Supply
+ -
Figure 4.18 - Relay 1-8 Connections-No PSS1
SS1
VIA-NET
IR
PWR
Figure 4.19 - VIA!NET/ZNET Connections-No PSS1
Normally Closed
SS1
Relay Controlled Device
External AC Three-Way
SS1
AC
Power
Supply
Neutral
+ -
Relay Controlled Device
ELAN SS1 RJ-45 Pin-Out
TAB
© ELAN Home Systems 2007 • All rights reserved.
E L A N H O M E S Y S T E M S
Internal Voltage
SS1
+ -
Relay Controlled Device
SS1
Hot
Neutral Up Down
Relay Controlled Device
PIN # COLOR CODE
1 BLUE VIA Sense IN
2 WHITE/BLUE VIA IR OUT
3 ORANGE VIA NET RS-485-
4 WHITE/ORANGE VIA NET RS-485+
5 GREEN Z NET RS-485-
6 WHITE/GREEN Z NET RS-485+
7 BROWN GND
8 WHITE/BROWN N/C
CABLE
Insert wires in this order:
Blue
White/Blue
Orange
White/Orange
Green
White Green
Brown
White/Brown