Usb Serial Port; Connecting Between The Meter And Computer; Setting Of Usb Serial Ports - Tenma 72-1016 Operating Manual

Model 72-1016: OPERATING MANUAL

USB Serial Port

A. Connecting between the Meter and computer
(see figure 15)
B. Setting of USB Serial Ports
72-1016 Back Faceplate
Install the USB serial port driver according to the
Installation Guide & Computer Interface Software
To COMPUTER
before connecting the Meter and computer.
Check for the USB Serial port shown at the Control
Panel => System => Device Manager. Make sure
USB INTERFACE CABLE
connect the Meter and the computer with the same
port.
Please refer to the included "Installation Guide &
Computer Interface Software" for installing and
operating instructions of the 72-1016 Interface
(Figure 15)
Program..
The Meter is to be supplied from an identical USB port
complying with the requirement of Limit Power Source.
**END**
55
This Manual: http://www.manuallib.com/file/2587080