Attaching/Detaching Toe; Using The Dual Feed Position Lever; Adjusting The Amount Of Fabric Feeding Of The Dual Feed Foot - Brother 882-D10 Operation Manual

USING FUNCTIONS BY CONNECTING THE ACCESSORY TO THE MACHINE
h
Plug the connector of the dual feed foot
into the jack on the back of your machine.
i
Press to unlock all keys and
buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.

■ Attaching/detaching toe

Attach the toe by aligning the pins with the notches
and snap it into place.
a Pins
b Notches
If you push down on the front part of the dual feed
foot, the toe of the dual feed foot will snap off.
B-54

■ Using the Dual Feed Position Lever

When the feed position lever is up, the black roller
belt on the dual feed is not engaged.
When the feed position lever is down, the black
roller belt on the dual feed is engaged.
Note
• Do not operate the lever while sewing.
■ Adjusting the Amount of Fabric
Feeding of the Dual Feed Foot
The dual feed mechanism pulls the top fabric
according to the set stitch length. With troublesome
fabrics, fine tune the set length, by changing the
dual feed feed adjustment in the settings screen.
Note
• As a default, some keys mentioned in the
following procedures appear in light gray
and are not available. To enable the keys for
specifying the settings, attach the dual feed
foot to the machine. The keys are enabled
after the dual feed foot is detected.
a
Press .
→ The settings screen appears.
b
Display page 1 of the settings screen.