Brother 882-D10 Operation Manual page 198

TROUBLESHOOTING
Problem
High-pitched sound Dust or lint is caught in the feed dogs.
while sewing
Pieces of thread are caught in the race.
Upper threading is incorrect.
There are scratches on the bobbin case.
A bobbin designed specifically for this machine
is not used.
Character pattern Wrong presser foot was used.
does not turn out
Pattern adjustment settings were set
incorrectly.
Did not use a stabilizer material on thin fabrics
or stretch fabrics.
Thread tension is set incorrectly.
Fabric was pulled, pushed or fed at an angle
while it was being sewn.
Machine does not There is no pattern selected.
operate
"Start/Stop" button was not pushed.
Main power switch is not turned on.
Presser foot is not lowered.
"Start/Stop" button was pushed with the foot
controller attached.
The "Start/Stop" button was pressed while the
machine is set for the sewing speed controller
to control the zigzag stitch width.
All keys and buttons have been locked by
Nothing happens, The screen has been locked.
even if the LCD
display is pressed
The fabric feeds in the The feed mechanism is damaged.
opposite direction.
The LCD screen is Condensation has formed on the LCD screen.
fogged up.
• This machine is equipped with a thread detection device. If the "Start/Stop" button is pushed before the
upper threading is done, the machine will not operate properly. Also, depending on the pattern selected,
the machine may feed the fabric even if the needle is raised. This is due to the needle bar release
mechanism. At these times, the machine will make a sound different from what is made during normal
sewing. This is not the sign of a malfunction.
• If the power is disconnected during sewing:
Turn the main power to OFF and unplug the machine.
If you restart the machine, follow the instructions for operating the machine correctly.
A-28
Cause
.
CAUTION
Solution
Remove the dust or lint.
Clean the race.
Check the steps for threading the machine
and rethread the machine.
Replace the bobbin case, or consult your
authorized dealer.
Incorrect bobbins will not work properly. Only
use a bobbin designed specifically for this
machine.
Attach the correct presser foot.
Revise the pattern adjustment settings.
Attach a stabilizer material.
Adjust the thread tension.
Sew while guiding the fabric with your hands
so that the fabric is fed in a straight line.
Select a pattern.
Press the "Start/Stop" button.
Turn the main power to ON.
Lower the presser foot.
Remove the foot controller, or use the foot
controller to operate the machine.
Use the foot controller instead of the
"Start/Stop" button to operate the machine,
or set the "Width Control" to "OFF" in the
settings screen.
Press to unlock all keys and
buttons.
Press either of the following keys to unlock
the screen.
Contact your dealer or the nearest authorized
service center.
After a while, the cloudiness will disappear.
Page
A-15
A-15
B-40
A-15
B-37
S-67
S-82
S-81
S-12
S-3
S-21, S-77
B-11
B-17
B-11
S-4
B-23, S-4
B-47, B-49
—
—
—