Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet 2010 Cobalt Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,
push the turn signal lever away from you.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

To signal to a driver in front of you that you want to
pass, pull the turn signal/multifunction lever until the
high-beam headlamps come on. Then release the lever
to turn them off.
This indicator light
appears on the instrument
panel cluster when the
high beams are on.
I n f o r ma t i o n P r o v i d e d b y :

Windshield Wipers

The windshield wiper lever is on the right side of the
steering column.
Move the lever to control the windshield wipers.
9 (Off): Turns the windshield wipers off.
& (Intermittent; Speed Sensitive Wipers): For
intermittent or speed sensitive operation. The amount
of delay time varies between wiping cycles due to the
delay setting selected or the speed of the vehicle.
As vehicle speed is increased or decreased, the wiper
interval also increases or decreases.
4-5