Rear Door Security Locks (Sedan); Lockout Protection - Chevrolet 2010 Cobalt Owner's Manual

Rear Door Security Locks (Sedan)

Your vehicle has rear door security locks. These
prevent passengers from opening the rear doors from
the inside.
Security Lock Label shown
To set the locks, do the following:
1. Insert the key into the security lock slot and turn it
so the slot is in the horizontal position.
2. Close the door.
The rear door security
locks are located on the
inside edge of each rear
door. You must open the
rear doors to access
them. The label showing
lock and unlock positions
is located near the lock.
I n f o r ma t i o n P r o v i d e d b y :
When you want to open a rear door when the security
lock is on, do the following:
1. Unlock the door using the remote keyless entry
transmitter, if the vehicle has one, the power door
lock switch, or by lifting the rear door manual lock.
2. Open the door from the outside.
To cancel the rear door security lock, do the following:
1. Unlock the door and open it from the outside.
2. Insert the key into the security lock slot and turn it
so the slot is in the vertical position.

Lockout Protection

If your vehicle has power door locks, it will have this
feature. If you press the power door lock switch when
the key is in the ignition and any door is open, all
the doors will lock and the driver's door will unlock.
Be sure to remove the key from the ignition when
locking your vehicle.
The lockout protection can be overridden by pressing
and holding the power door lock in the lock position for
three seconds.
3-11