ETA Systems PD11VBC Owner's Manual

Power protection series

Advertisement

Quick Links

PD11VBC
Power Protection Series
Owner's Manual
TM
®
TM
®
A Creative Light And Sound Company
A Creative Light And Sound Company
1532 Enterprise Pkwy, Twinsburg OH 44087 • (800) 321-6699 • (330) 425-3388 • www.etasys.com
1532 Enterprise Pkwy, Twinsburg OH 44087 • (800) 321-6699 • (330) 425-3388 • www.etasys.com
6MAN-037

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PD11VBC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ETA Systems PD11VBC

  • Page 1 PD11VBC Power Protection Series Owner’s Manual ® ® A Creative Light And Sound Company A Creative Light And Sound Company 1532 Enterprise Pkwy, Twinsburg OH 44087 • (800) 321-6699 • (330) 425-3388 • www.etasys.com 1532 Enterprise Pkwy, Twinsburg OH 44087 • (800) 321-6699 • (330) 425-3388 • www.etasys.com...
  • Page 2 A Creative Light And Sound Company 1532 Enterprise Pkwy, Twinsburg OH 44087 • (800) 321-6699 • (330) 425-3388 • www.etasys.com © 2003 ETA Systems SIDACtor is a registered US trademark of Teccor Electronics, inc. TiVo is a trademark of TiVo, Inc.
  • Page 3: Table Of Contents

    FAQs TABLE OF CONTENTS My PD11VBC power cable does not The PD11VBC is ON but the Voltmeter is What is the difference between an Before You Begin............1 Voltage Sense Trigger..........8 reach the wall outlet. Can I use an not lit up. What is the problem? Overvoltage and Undervoltage? Introduction..............2...
  • Page 4: Introduction

    Please finish reading the Initial Clamping Level............200V Peak, 141V Rms Outlet Banks 1 & 2: power for your amplifiers and powered sub- instructions, install your PD11VBC and enjoy Clamping Level....................0.7V Response Time....................<1ns The primary filtration system features two woofers.
  • Page 5: Connection Diagram

    12VDC LINE OUTDOOR FM ANTENNA When the PD11VBC is subjected to a high voltage surge, its voltage output is limited to a safe level and the high levels MINI DISC PLAYER of surge current are diverted away from the connected equipment.
  • Page 6: Feature Overview

    Cable TV (Including HDTV) – TV tuners operate at approximately 10 millivolts (0.01 V) and utilize the frequency spec- trum of 50Mhz to 950Mhz. The clamping level of the PD11VBC’s cable TV protection circuitry is 700 millivolts (0.7 volts). That’s less than 1 volt above normal operating levels. The circuitry is shielded to prevent interference and has been opti- mized to have less than 1dB of signal loss throughout the entire 50Mhz to 950Mhz range.
  • Page 7: Voltmeter

    The high-current outlets are designed with a turn-on delay option of 0, 10 or 30 seconds. The 3-position, Delayed Outlet Turn-On Switch on the back of the PD11VBC is used to select the desired time delay. When a delay is selected, the high- current outlets will turn-on after Outlet Bank 2 and turn-off before Outlet Bank 2 (if they’re not set to Always-On).
  • Page 8: Filtered Outlet Banks 1 & 2

    Outlet Bank 2 contains four switched outlets that will turn your connected equipment ON or OFF with one of two PD11VBC Ground OK: Green LED. When this light is ON, it indicates that the wall outlet is properly wired. When the light is OFF, triggers (Switched Outlets push-button or Voltage Sense Trigger).

Table of Contents