Planar m40L Installation Manual page 37

Manual Level Adjustment
1 Select a source in the
2 To access the
INPUT LEVELS
3 Display an all-black picture from the source computer.
Note: Black Level must be done before White Level.
4 In the
INPUT LEVELS
down with the + or - keys to make the three
Once any value reaches zero, use the individual colors under
adjust the other two values to zero.
5 Display an all-white picture from the source computer.
6 Adjust
WHITE LEVEL
value reaches 255, use the individual colors under
other two values to 255 (or 254).
7 Although it is not required, we recommend that you save the configuration to a
memory slot. (See "Saving Configurations" on page 78)
8 If you have more than one source coming through the same connector, adjust
Input Levels for each source.
m40L/m46L Installation Guide
menu.
PICTURE
menu, press
I np u t L ev els
A ut o B la ck L eve l (o f f set )
A ut o W h it e L ev el ( ga in )
C en t er P oi n t
B l ac k L ev el ( o f fs et ) -A l l
R ed
G r e e n
B lu e
Wh ite L eve l (g a in )-A ll
R ed
G r e e n
B lu e
menu, select
BLACK LEVEL
( ) until the
GAIN CENTER POINT
Adjusting Levels for Analog Sources
on the remote.
LEVEL
64 12 4 99
79
89
67
83
99
99
99
99
( ) and adjust it up and
OFFSET
values go to zero.
CENTER POINT
BLACK LEVEL
values go to 255. Once any
WHITE LEVEL
to
to adjust the
27