Charging The Speaker; Pairing Your Device - Brookstone BIG BLUE UNPLUGGED User Manual

CHARGING THE SPEAKER

1. The speaker can be charged two ways:
• Lift the port cover and insert the DC ADAPTER into the
DC IN PORT on the speaker. Plug the DC ADAPTER into
an electrical wall outlet. The speaker will be fully charged
in approximately 4 hours.
• Lift the port cover and insert the MICRO USB CHARGING
CABLE'S DC JACK into the DC IN PORT on the speaker.
Plug the MICRO USB CHARGING CABLE'S USB
connection into a travel USB adapter (5V, 1A or above)
(not included). The speaker will be fully charged in
approximately 7 hours.
2. The CHARGING LED INDICATOR is RED while the
speaker is charging. When the speaker is fully charged,
the CHARGING LED INDICATOR turns off. For first
time use, fully charge the speaker.
3. When the speaker's battery is low, the CHARGING LED
INDICATOR will flash RED.
10

PAIRING YOUR DEVICE

1. Prepare your device to pair using Bluetooth
making sure the device is within 33 feet of the speaker.
Refer to your device's owners manual for details if
necessary.
2. Press and hold the POWER/PAIRING BUTTON until
the LED RING turns on and the power on tone sounds.
3. Press the USER BUTTON until the desired USER LED
INDICATOR is illuminated. The USER LED INDICATOR
will blink slowly if it has been previously paired with a
device and then solid when the device is found, or it
will flash rapidly indicating no device was previously
paired to that User.
4. Press and hold the POWER/PAIRING BUTTON until the
LED RING starts flashing to put the speaker in pairing
mode.
5. Select "Big Blue Unplugged" on your device. If prompted,
use 0000 as a PIN for the pairing code. The speaker will
wait for a connection in pairing mode for up to 2 minutes.
® technology,
11