Hotpoint RGB751GEL Use And Care Manual page 10

Electronic
Automatic Oven Timer
The oven timer will automatically
start and stop your oven cooking or
self-cleaning operation for you.
For automatic oven cooking:
1. Push COOK TIME button.
2. Turn SET knob to set length of
baking time.
3. Push BAKE button.
4. Turn SET knob to set desired
temperature.
When cook time is reached, the
End-of-Cycle Tone will sound and
the oven will turn off.
During automatic cooking:
You can push the STOP TIME
button to find out when the End-of-
Cycle Tone will sound and the oven
will turn off.
. You can push the CLOCK button
to display time of day without
canceling the oven operation.
To Delay Starting an
Automatic Oven Operation
If
delayed cooking operation
a
is desired:
1. Push COOK TIME button.
2. Set length of baking time with
SET knob.
3. Push STOP TIME button.
4. Turn SET knob to time of day
when baking should be completed.
Stop time must be equal to or
greater than the cooktime plus the
current time of day.
5. Push BAKE button.
6. Turn SET knob to desired
temperature.
When stop time is reached, the
End-of-Cycle Tone will sound and
the oven will turn off.
Caution: Never let food sit in the
oven for more than 4 hours before
cooking starts. Room temperature
is ideal for the growth of harmful
bacteria. Be su~e oven light is off
because heat from the bulb will
speed bacteria growth.
Note: You can push the SlOP
TIME button to find out when the
oven will turn off. Push and hold
the COOK TIME button to find out
when the oven will turn on.
If a delayed self-cleaning oven
operation is desired, see page 20.
How to Change
a Program
When a function has been
entered, you can recall what has
been programmed by pushing the
corresponding function button.
The messages in the display show
you which function is currently
being displayed. While the
change it with the SET knob.
You can change any progmmrned
function at any time.
10
Tones
End-of-Cycle Tone (3 long beeps—
one second on, one second off):
shows that a timed oven operation
has reached STOP TIME or that
the Minute/Second Timer has
counted down.
Attention Tone (series of short
beeps, l/4-second on, l/4-second
off, until proper response is given):
will sound if oven has only been
partially programmed. For example,
if you have selected a cook time but
no temperature, you will hear the
Attention Tone until you select a
temperature or push CANCEL.
Notification Tone (single, one-
second beep): indicates oven has
stabilized at selected temperature.
Key Tone (single, l/10-second
beep): sounds when any button is
pushed.
Function Error Tone (series of
very rapid beeps, l/8-second on,
l/4-second off): display will show a
failure code. Cancel Function Error
Tone by pushing the CANCEL
button. If the Function Error Tone
starts again (after about 15
seconds), call for service.
Disconnect the range electrical
supply to stop the tone.
If the function error occurred
while you were programming the
Electronic Control, push the
CANCEL button and try again.
To Cancel the Tone... If you don't
want an audible tone when you push
a button, you can eliminate the Key
Tone by pushing and holding the
CANCEL button until you hear a
short beep (in approximately two
seconds). To activate the tone again,
push and hold the CANCEL button
once more until you hear a short
beep. Canceling or activating the
tone should only be done when there
is no oven operation programmed.
Pushing the CANCEL button will
clear all functions except the Clock
and Minute/Second Timer.