Vr2-L - Quickie Salsa Instructions For Use Manual

7.2 VR2-L

There are common controls between the VR2 and the
VR2-L control systems where a control differs it will be
described below. All common controls can be found on the
previous page.
Lights and indicators:
The SALSA can be equipped with lights and indicators.
Where lights are not factory fitted, they may be fitted as an
optional extra by an approved Sunrise Medical authorised
dealer.
WARNING!
Ensure that the lights and indicators are functioning
correctly and lenses are clean before going outdoors at
night.
Indicators:
To turn on the wheelchairs indicators operate the required
button either left or right, the associated LED will also
illuminate continuously.
Depress the indicator button to turn off the indicator and
the associated LED
CAUTION!
If the LED flashes rapidly either a total short circuit, a single
lamp open circuit or a total open circuit in the left or right
indicator circuit has been detected
Main lights:
To turn on the wheelchairs lights operate this button, the
associated LED will illuminate continuously.
Depress the light button to turn off the lights and the
associated LED
CAUTION!
If the LED flashes a short circuit in the lighting circuit has
been detected.
40
SALSA M
Hazard warning lights:
To turn on the wheelchairs hazard warning lights operate
this button, the associated LED will flash at the same rate.
The left and right turn indicator LEDs will also flash.
Depress the hazard warning button to turn off the lights
and the associated LED.
CAUTION!
If the LED flashes rapidly either a total short circuit, a
single lamp open circuit or a total open circuit in the entire
indicator circuit has been detected
Actuator button and LEDs:
Depending on whether your wheelchair is fitted with one or
two actuators the operation of this button will differ.
Wheelchairs with one actuator
Depressing the actuator button will enter actuator
adjustment mode. This will be indicated by the illumination
of both actuator LED's. Actuator adjustment can then be
made by deflecting the joystick forwards or backwards. To
re enter drive mode, depress either actuator button
Wheelchairs with two actuators
Depressing the actuator button will enter actuator
adjustment mode. Depressing the button once illuminates
the left LED, and deflection of the joystick will adjust the
actuator motor connected to that channel. If the right
button is depressed the associated LED will be illuminated,
and deflection of the joystick will adjust the actuator motor
connected to the other channel.
To re enter drive mode, depress the selected actuator
button, as indicated by the associated LED
It is also possible to select the other actuator by left or right
movements of the joystick
R-net Control
Please refer to your R-net Owner's Manual for
details.