Seat Height Adjustment; Seat Width Adjustment - Quickie Salsa Instructions For Use Manual

6.6 Seat height adjustment

WARNING!
Make sure the top frame does not trap your fingers. Get
someone to hold the seat steady during adjustment.
To change the seat height:
Salsa Rear Wheel Drive only:
• Remove the two bolts from the front seat posts, using a
5mm allen key.
• Access the bolts by removing the front cover.
• Take the safety clips off the flat rear posts, pull the ring
pins out and loosen the two clamping bolts.
• Lift/lower the seat height by choosing the required hole
position on the rear seat posts.
• Replace the pins, clips and bolts. Tighten the bolts.
• Choose the matching set of holes for the front seat posts.
Replace and tighten the bolts, (Fig.6.4 - 6.5).
Salsa Mid-Wheel Drive only:
• Undo the 2 hand-wheels at the front, pull the release pin
& tilt the seat back.
• Remove the 2 socket studs from the back seat posts.
• Lift/lower the seat to the required position.
• Align the holes then refit & tighten the socket studs.
• Remove the 2 socket studs from the front seat posts.
• Lift/lower the posts to match the required position.
• Align the holes then refit & tighten the socket studs.
• Close the seat, refit & tighten the hand wheels (fig.6.6).
Fig. 6.4
Fig. 6.5
Fig. 6.6

6.7 Seat width adjustment

1. Remove the 5mm width adjustment bolts (A) and the
4mm towel bar adjustment bolt (B), (Fig.6.7) .
2. Move the left side seat rail, armrest and backrest
assembly to the desired position. See seat width position
settings (C), (Fig.6.8).
Fig. 6.8
Fig. 6.7
31
SALSA M