Sub-Zero UC-15I Service Manual page 52

Component Access / Removal
Interior Components
Water Paddle Removal
The water paddles reduce the spraying water escaping
the evaporator compartment. A steel rod which sup-
ports the water paddles sits in grooves molded into the
evaporator cover.
NOTE: Also see Water Shutter Assembly Removal
under Components Below Top Cover.
To remove the water paddles (See Figure 5-19):
1. Grasp both ends of water paddle assembly.
2. Lift one end of of water paddle assembly up while
pivoting forward.
3. After first end is disengaged, pull other end forward
to disengage rod from groove and pull assembly
from bin area.
NOTE: The individual water paddles will slide off
steel rod unless held at both ends while removing.
Ice Chute Removal
The ice chute is positioned over the spray nozzles and
allows the ice to easily fall into the bin.
To remove the ice chute, grab protruding spray hole on
one end, lift up and pull forward out of evaporator/spray
bar enclosure (See Figure 5-20)
NOTE: When reinstalling ice chute, it must be firmly
positioned over the spray bar, with the front edge inside
the water trough. Spray nozzles must be align with the
spray holes or spray water will fall into the bin.
Water Trough Drain Tube and Standpipe/Overflow
Tube Removal
To remove the drain tube and overflow tube (See Figure
5-21):
1. At top of drain tube, disengage tube clamp teeth
and remove clamp from tube and water trough nip-
ple.
2. Pull drain tube up out of bin drain.
3. Pull drain tube and standpipe/overflow tube down
out of water trough (water in the trough will drain
into the bin).
4. Remove standpipe/overflow tube from drain tube by
pulling.
#7012423 - Revision A - August, 2009
Model UC-15I (Undercounter Ice Machine)
5-10
E v a p o r
Water
Paddles
Figure 5-19. Water Paddle Removal
Figure 5-20. Ice Ramp Removal
Standpipe /
Overflow Tube
Figure 5-21. Drain Tube & Overflow Tube Removal
v e r
a t o r C o
Remove Rod
From Groove
Ice Ramp
Clamp
Drain Tube