Sub-Zero UC-15I Service Manual page 45

Model UC-15I (Undercounter Ice Machine)
Exterior Components
Kickplate Removal
The kickplate is held in place with four screws, two
along each side. To remove the kickplate, extract the
screws and pull the kickplate forward. (See Figure 5-1)
Door Panel Removal
The handle-side panel mounting bracket is attached to
the back side of the door panel with screws. The tabs
of the handle-side bracket then slide into slots in the
face of the door. Screws passing through the top and
bottom panel mounting brackets, from back to front, into
the door panel hold the panel tight to the door.
To remove a door panel (See Figure 5-2):
1. Open the door, then extract the door panel mount-
ing screws from bottom and top brackets.
2. Slide panel towards the hinge side to disengage the
handle-side bracket from slots in face of door.
Door Panel Mounting Brackets and Door Hinge
Cover Removal
The top and bottom panel mounting brackets, as well
as the door hinge cover are attached to the face of the
door with screws.
To remove a panel bracket or door hinge cover, the
door panel will need to be removed first. Then, extract
the bracket or hinge cover mounting screws and pull
the bracket or hinge cover form the face of the door
(See Figure 5-2).
Door Gasket Removal
The door gasket has a rib on its back side that fits into
a channel in the door liner.
To remove the door gasket, open the door and pull the
gasket from the channel in the door liner (See Figure 5-
3).
Figure 5-1. Kickplate Removal
Bottom Bracket
Handle-Side Bracket
Figure 5-2. Panel Mount Hardware
& Upper Door/Hinge Cover Removal
Door
Gasket
Figure 5-3. Door Gasket Removal
5-3
Component Access / Removal
Kickplate
Screws
Door/Hinge
Cover
#7012423 - Revision A - August, 2009
Top
Bracket
r
D o o
e l
P a n