Sub-Zero UC-15I Service Manual page 18

Installation Information
2. Remove the hinges from the door by removing the
four screws (two each hinge) that secure the hinges
to the door. Refer to the illustration below.
3. Remove the upper plastic trim piece (right hand
configured) from the door by removing the two
screws that secure it to the door. Then replace it
with left hand trim piece. Refer to illustration below.
4. Transfer the hinges to the left side of the door and
re-attach. The upper hinge will need to become the
lower hinge and the lower hinge will now need to
become the upper. Refer to the illustration below.
Step 2
Step 3
Step 2
Remove Hinges
and Plastic Trim
5. Remove the top ice machine cover by removing the
two screws along the back of the unit. Refer to the
illustration below.
Remove Top Cover
#7012423 - Revision A - August, 2009
Model UC-15I (Undercounter Ice Machine)
Step 4
Hinge Transfer
Step 5
6. Remove four screws from the front top rail. Refer
to the illustration below.
7. Pivot top rail end for end to expose the two left
hand top hinge screw holes and reinstall.
Reversing Top Rail
8. Remove 2 screws from bottom trim plate and slide
to cover right hand hinge mounting screw holes and
expose left hand hinge mounting screw holes.
Refer to illustration below.
Repositioning Slide Rail
9. Install the door using the left-hand door mounting
holes. Install shim removed in step 1 between the
hinge and cabinet.
10. Check the operation of the door by opening.
2-10
Step 6
Step 8