Chapter 3: Setup; Entering Setup Mode - Projectek Networking Electronics BESTip ATA GSM User Manual

Chapter 3: Setup

After connection, follow the easy instructions to setup the
BESTip ATA GSM. You can establish your setup or modify it at
any time by launching the BESTip.
Make sure the BESTip is well connected and you must allow
the BESTip to finish booting before you enter the setup mode.

Entering Setup Mode

1. After switching on, the BESTip
will start self-testing, and the LCD
screen will display as shown right.
2. After finishing initializing, the
system will start up DSP.
3. For the first time, the LCD will
display Enter Setup Mode - Push
Down=Yes. Press button
on the front panel to enter setup
mode.
Note: At the BESTip finishes booting, you can always use
or buttons to scroll the menu and press
to enter the current menu.
BESTip ATA GSM User Manual
button
11
BESTip ATA GSM User Manual
1. You can press "DOWN" button at standby status to enter main
menu.
2. Then, you can press "NEXT" or "BACK" button to scroll the menu.
12
Press "Down" button
to enter main menu.
Press "NEXT" button
to scroll the menu.
Press "BACK" button
to scroll the menu.