Function Select－Recharge Credit; Function Select－Factory Setting - Projectek Networking Electronics BESTip ATA GSM User Manual

2. Press or buttons to
scroll the options.There are four
options to select: Enabled & Disable.
Press to confirm your target
option and back to the upper menu.
Function Select－Recharge Credit
1. Press button to enter the
Function Select Mode.
2. Press or button to
scroll the main menu till it appears
Function Select – Recharge Credit.
And then press to enter the
option.
3. Press to start recharging
credit.
4. Enter Card #: Press
one time, the title will start flashing
and enter the card #. Press
button again. The title will stop
flashing and save the card #.
5. Enter PINCIDE Press
one time, the title will start flashing
and enter the card #. Press
button again. The title will stop
flashing. The new value will be
stored temporarily.
BESTip ATA GSM User Manual
31
BESTip ATA GSM User Manual
6. Press button to confirm.
Start Recharge will shows. The
process will take a few minutes.
7. When recharge finished, the total
amount will be shown on the display.
Function Select－Factory Setting
BESTip has the auto-recovery capability. Just follow the steps
below to restore the factory settings.
Note: Before proceeding to restoring, be sure that your BESTip
is connected to the Internet.
1. Press button to enter the
Function Select mode.
2. Press or button to
scroll the main menu till it appears
Function Select - Factory Setting.
And then press to enter the
option.
3. There are one option of Factory
Setting: CLEAR SYS SETUP.
Press to start the process.
4. Press to to clear device
setup.
32