Asus P5K64 WS User Manual page 50

•
When using hot-plug and NCQ, set the Configure SATA as in the BIOS to
[AHCI]. See section 4.3.6 SATA Configuration for details.
4. USB connectors (10-1 pin USB 7 8, USB 9 10, USB 11 12)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
P5K64 WS USB 2.0 Connectors
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
If your chassis suppots front panel USB ports, you can attach a front panel
USB cable to these connectors. Connect the USB cable to ASUS Q-Connector
(USB, blue) first, and then install the Q-Connector (USB) to the USB connector
onboard.
2-24
You must install the Windows
hard disk drives. The Serial ATA RAID feature (RAID 0 and RAID 1) is
available only if you are using Windows
Connect the right-angle side
of SATA signal cable to SATA
device. Or you may connect the
right-angle side of SATA cable to
the onboard SATA port to avoid
mechanical conflict with huge
graphics cards.
USB1112
XP Service Pack 1 before using Serial ATA
®
XP or later version.
®
right angle side
1
USB910
1
Chapter 2: Hardware information
USB78
1