Universal Garage Door Opener (Homelink®) - Chrysler Town & Country 2011 User Manual

Hide thumbs Also See for Town & Country 2011:
Table of Contents

Advertisement

Auto Door Lock
• To have the doors lock automatically when the vehicle's speed exceeds 15 mph (24 km/h):
• Enter your vehicle and close all the doors.
• Cycle the ignition switch between LOCK and ON and then back to LOCK four times,
ending up in the LOCK position (do not start the engine).
• Press the power door LOCK switch to lock the doors. A single chime will indicate that
programming is complete.
Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:
• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then, press
the PANIC button while still holding the LOCK button.
• Release both buttons at the same time.
Flashing Lights With Lock
• The turn signal lights flashing, when the doors are locked or unlocked, feature can be turned on
or off. To turn this feature on or off:
• Press and hold the UNLOCK button for at least 4 seconds, but no longer than 10 seconds.
Then, press and hold the LOCK button while still holding the UNLOCK button.
• Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink® buttons while keeping
the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink® button and the hand-held
transmitter button until the HomeLink® indicator flash rate changes from a slow to a rapidly
blinking light, then release both the HomeLink® and the hand-held transmitter buttons. This
may take up to 30 seconds, or longer in rare cases.
• Press and hold the just-programmed HomeLink® button; if the indicator light stays on
constantly, programming is complete and the garage door should open.
ELECTRONICS
Programming HomeLink®
Begin Programming
• The HomeLink® buttons are located in the
overhead console.
• Erase all channels before you begin
programming by holding the two outside
buttons for up to 20 seconds until the red
indicator flashes.
47

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents