Table of Contents
Advertisement
MT. VERNON AE
F. Quick Start Guide
Any button pressed will turn on the backlight. Wall control will automati-
NOTICE:
cally revert back to the starting screen if there is no activity for 15 seconds; except
for the "CONFIRM FUEL CHANGE" screen.
Buttons
READY
12:30 PM
Set at: 73
73
Room
Temp
MENU
HEAT OUTPUT
Function Buttons
Wall Control for Reference
TURNING ON APPLIANCE
12:30 PM
READY
Set at: 68
71
MENU
1.
At the starting screen, press "MENU".
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
2.
Highlight "AUTO/MANUAL/OFF".
Press "SELECT".
AUTO/MANUAL SETTINGS
Automatic
Manual
Manual
Off
3.
Highlight "MANUAL". Press "SELECT
4.
Press "DONE" twice or wait 15 seconds
for starting screen to re-appear.
18
CHOOSING FUEL TYPE
Up
Down
1.
At the starting screen, press "MENU"
button once or twice until "MENU"
screen appears.
2.
Highlight "FUEL TYPE" using the "UP/
DOWN" buttons to the right side of the
display. Press "SELECT".
3.
Scroll down and highlight "HARD-
WOOD PELLET" or your fuel type.
4.
Now press "SELECT" to choose new
fuel.
".
5.
Press
change.
6.
Press "DONE" twice or wait 15 sec-
onds for starting screen to reappear.
7.
Fill the hopper with fuel. If the hopper
was completely empty or has run out of
fuel, put approximately 1/2 cup of pel-
lets into the fi repot for a quick restart.
8.
Be sure the hopper lid and glass door
are both closed.
READY
12:30 PM
Set at: 68
71
MENU
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
FUEL SELECTION
Softwood Pellet
Sunflower Seeds
Wheat
Hardwood Pellet
CONFIRM FUEL CHANGE
Please empty hopper
of old fuel type and
ensure firebox is clean.
Please refer to
section 8 in manual.
DONE
"DONE"
to
confi rm
fuel
7034-276E
CHOOSING TEMP UNIT:
°F or °C
READY
12:30 PM
Set at: 68
71
MENU
1.
At the starting screen, press "MENU"
button once or twice until "MENU"
screen appears.
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
2.
Highlight "USER SETTINGS" using
the "UP/DOWN" buttons to the right
side of the display. Press "SELECT".
USER SETTINGS
Temp Units F/C
Flame Height Adjust
Temp Differential
3.
Highlight "TEMP UNITS F/C" using the
"UP/DOWN" buttons to the right side of
the display. Press "SELECT".
4.
Press the "UP" or "DOWN" button
to set desired temperature unit and
press "SELECT"..
5.
Press "DONE" twice again, or wait 15
seconds for starting screen to re-ap-
pear.
October 13, 2015
Advertisement
Table of Contents
