Advertisement
Table of Contents
Warranty
RemoteMix 4 is covered by a two year warranty to be free from
defective workmanship and materials. In the event that the
RemoteMix 4 needs repair, you must call us to get an
RemoteMix 4
authorization, and then carefully pack and ship it to us. You
will pay for shipping to us and we will pay for return back to
you, UPS ground. No free repairs will be made if the defect
was caused by misuse, weather conditions, or other cause,
Portable Broadcast Mixer
except for defective workmanship or materials. THERE ARE
NO EXPRESSED OR IMPLIED WARRANTIES WHICH
EXTEND BEYOND THE WARRANTY HERE MADE.
User Guide
08/07
JK Audio
JK Audio, Inc.
1311 E 6th Street, Sandwich, IL 60548
USA
Voice: (815) 786-2929
Toll Free: 800-JK-Audio
Fax: 815-786-8502
info@jkaudio.com
www.jkaudio.com
Copyright © 2007 JK Audio, Inc.
All rights reserved.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for JK Audio RemoteMix 4
Summary of Contents for JK Audio RemoteMix 4
- Page 1 Warranty RemoteMix 4 is covered by a two year warranty to be free from defective workmanship and materials. In the event that the RemoteMix 4 needs repair, you must call us to get an RemoteMix 4 authorization, and then carefully pack and ship it to us. You will pay for shipping to us and we will pay for return back to you, UPS ground.
- Page 2 *The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. The internal antennas used for this mobile transmitter must not be co- and any use of such marks by JK Audio, Inc. is under license. Other trade- located or operated in conjunction with any other antenna or transmitter.
-
Page 3: Fcc Registration
FCC Registration Connection Your new JK Audio product has been registered with the Federal 1. Mic inputs 1 and 2 are balanced XLR jacks with low-noise amplifi- Communications Commission (FCC). This product complies with the ers. standards in Part 68 of the FCC rules. -
Page 4: Specifications
1. Connect your audio equipment, microphones, cue input, and Microphones(4): Female XLR 2k ohm, (-25 dBu nom.) headphones to the input and output jacks on RemoteMix 4. Channels 3 & 4 have -40 dB Mic/Line pad switch 2. (a) Connect the jack marked "Phone Line" to any standard Line = +4 dBu nom., +16 dBu max.,... -
Page 5: Block Diagram
Block Diagram Operation Phone Line The RemoteMix 4 has an RJ-11 jack that can be connected to any standard, single line analog telephone line. This jack should not be connected directly to digital PBX or ISDN phone systems. Handset Interface... - Page 6 Mix of the mic and line inputs from the internal mixer or the Return I've lost my power supply for my RemoteMix 4 unit. I have a power audio from the phone line which will also contain some of the mic supply that fits from a different product.
- Page 7 The telephone keypad provides DTMF tone dialing. You may use the The audible ringer found on some of our other RemoteMix units was re- placed with a visual ring indicator on the RemoteMix 4. This red LED keypad at anytime during a call but keep in mind that both transmit flashes when a call comes in.
- Page 8 Monitor the Bluetooth audio path on headphones in the "Return" po- and right audio paths from the Bluetooth device are mixed together sition on the RemoteMix 4. Pull up on the Bluetooth switch on the before reaching the Receive bus. This is a full bandwidth (20 Hz to RemoteMix 4 and hold for approximately 5 seconds.
Need help?
Do you have a question about the RemoteMix 4 and is the answer not in the manual?
Questions and answers