Advertisement
13
-—. ...... . —.- —-. -..—.——.——.—
.——.—.———.——
To replace hood lamp, first disconnect power at main
and roll top of lamp gently toward front until it stops. Re-
fuse or circuit breaker panel or pull plug. Remove 2
move. Replace with same type and wattage lamp. Hold
screws from each side of lower panel and 3 screws from
lamp near each end and insert prongs in sockets. Gently
front edge. Lower panel until it rests on range below.
roll top of lamp toward rear of range until it stops. Raise
Place fingers on top near each end of lamp. Press down
lower panel and replace screws.
To replace your oven lamp, first disconnect power at
Clean off the grease and dust on hood surfaces often.
main fuse or circuit breaker or pull plug. Remove the
Use a warm detergent solution. About 1 tablespoon of
top grill by taking off 2 screws which hold it in place.
ammonia may be added to the water. Take care not to
-
Next, remove the single screw on top left that secures
touch the filters and enameled surfaces with this. Ammo-
.=-
lamp housing. Open oven door for easier removal of the
nia will tend to darken metal.
lamp housing assembly. Then grasp tab and pull out and
p to clear door hinge and front lip of oven. To remove
bulb, push it inward gently and turn to left, then pull
outward from socket. Replace with GE Lamp #25T8DC.
Do not
tooperate the oven unless the grill is
in place.
Advertisement
