Setting The Temperature - Danfoss CET2000B-RF + RX1-S + CS2 User Manual

Setting the temperature

Press either the Λ or V buttons, the product backlight will come
on.
Press either the Λ or V button again within 6 seconds, the display
will flash with the current set temperature. While the display is
flashing press the Λ arrow to increase the set temperature to the
required setting or the V arrow to decrease the set temperature.
If no buttons are pressed the display will return to actual
temperature after 4 seconds and the backlight will go out after
6 seconds.
Please Note: In order to reduce the risk of Legionella infection, it is
recommended that water be stored at not less than 60°C.
8 CET2000B-RF