BATTERY CHARGING AND STARTING SYSTEMS
Commander 2000 Key Switch Test
1. Disconnect remote control wiring harness and instrument panel connector.
2. Set ohmmeter on R x 1 scale for the following tests:
CONTINUITY SHOULD BE INDICATED AT THE FOLLOWING POINTS:
KEY
POSITION
BLK
OFF
RUN
START
CHOKE*
*NOTE: Key switch must be positioned to "RUN" or "START" and key pushed in to
actuate choke for this test.
3. If meter readings are other than specified in the preceding
not wiring is faulty. If wiring checks ok, replace switch.
Page 2B-14
BLK/YEL
RED
YEL/RED
PUR
verify that switch and
tests,
90-826883R2 JUNE 1998
YEL/BLK