Required Side Mount Remote Control Or Ignition Key Switch Assembly; Boats Equipped With Side Mount Remote Control; Boats Equipped With Panel Or Console Mount Remote Control; Remote Wiring Connections - Mercury OUTBOARD MOTOR Installation Manual

Required Side Mount
Remote Control or Ignition
Key Switch Assembly
Boats Equipped with Side Mount
Remote Control
A Quicksilver Commander 2000 series Side Mount
Remote Control equipped with a warning horn must
be used with this outboard. This warning horn is nec-
essary for the engine warning system.
a -Warning Horn
Boats Equipped with Panel Or
Console Mount Remote Control
A Quicksilver Ignition
equipped with a warning horn must be used with this
engine. This warning horn is necessary for the en-
gine warning system.
a - Warning Horn

Remote Wiring Connections

Electric Start Remote Control Model

1. Route the remote wiring harness to the back of
the engine block as shown.
2. Plug the remote wiring harness into the engine
wiring harness connector.
3. Push connectors into the holder.
90-826148R2 MARCH 1997
a
Key/Choke Assembly
a
a
b
a
a - Remote Wire Harness
b - Engine Wire Harness Connector
c - Holder
Manual Start Models Using
Quicksilver 2000 Series Side Mount
Remote Control
1. Route the remote control harness around the
back of the engine block as shown. Position the
harness so that the harness will not interfere with
shift and throttle operation.
a
a - Remote Control Harness
2. Fasten the black wire from the remote control
harness to engine ground and connect the black/
yellow from the remote control harness to the
black/yellow engine wire as shown.
a
ENGINE GROUND
a
BLK/YEL
a - Black Wire
b - Black/Yellow Lead
IMPORTANT INFORMATION - 1D-7
c
b
BLK/YEL