Sharp AL-2051 Service Manual page 99

Main Sub
Contents
code code
48 01 Front/rear (main scanning)
direction and scan (sub
scanning) direction
magnification ratio
adjustment
05 RSPF mode sub scan
direction magnification ratio
in copying
[Function]
Used to adjust the magnification ratio in the main scan (front/rear) direction and sub scan direc-
tion.
Enter the adjustment value with [Numeric] key. Press [START] key to save the set value and
make a copy. (When the adjustment value is increased by 1, the magnification ratio is increased
by 0.1%.)
The adjustment mode can be changed by pressing [
(Adjustment range: 1 – 99, Default: 50)
Mode
Main scan direction magnification ratio
OC mode sub scan direction
magnification ratio
[Operation]
The operation is similar to simulation 46-01.
[Function]
Used to display the current RSPF mode sub scan direction magnification ratio on the LCD/dis-
play.
When [START] key is pressed, the entered data is acquired and saved into the EEPROM, and a
copy is made. (When the set value is increased by 1, the magnification ratio is increased by
0.1%.)
The adjustment mode can be changed by pressing [
Default: 50)
When adjusting the RSPF, the mode is set to "Duplex
performed.
For printing, regardless of the density mode and the density level,
Density mode = MANUAL
Density level = 3
Mode
Sub scan magnification ratio
adjustment on the front surface of
RSPF document
Sub scan magnification ratio
adjustment on the back surface of
RSPF document
* When there is no document in RSPF, copy is inhibited.
[Operation]
The operation is similar to simulation 46-01.
AL-2051 SIMULATION, TROUBLE CODES 10 - 23
Details of function/operation
] [ ] key.
Display item
F-R PRINT mode lamp
SCAN SCAN mode lamp
] [ ] key. (Adjustment range: 1 – 99,
→
Single," single copies of two sheets are
Initial value of
Display item
duplex setting
S-S SIDE1
D-S SIDE2
LED Default
50
50
LED Default
COPY mode 50
lamp
PRINT mode 50
lamp