Sharp AL-2051 Service Manual page 88

Main Sub
Contents
code code
26 20 Rear edge void setup
30 CE mark support control
ON/OFF
38 Cancel of stop at drum life
over
39 Memory capacity check
40 Polygon motor OFF time
setup (Time required for
turning OFF after completion
of printing)
[Function]
When this simulation is executed, the current set rear edge void is displayed. Enter the code
number corresponding to the desired rear edge void and press [ENTER]/[START] key to save
the setting.
Code number
0 Rear edge void NO
1 Rear edge void YES
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current set CE mark support control is displayed. Enter
the code number corresponding to the desired CE mark support control and press [ENTER]/
[START] key to save the setting.
Code number
0 CE mark support control OFF
1 CE mark support control ON
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current setup of the code number is displayed. Enter the
code number and press the PRINT switch to enable the setup.
Code number
0 Stop at drum life over * Default (Overseas)
1 Cancel of stop at drum life over
[Operation]
The operation is similar to simulation 26-02.
[Function]
When the simulation is executed, the currently installed SDRAM of the main unit is displayed.
Code number
32 32 MBYTE
[Operation]
1) Memory capacity display
26-39 MEM.CHK
32 MBYTE
[Function]
When this simulation is executed, the current setting is displayed. Enter the code number corre-
sponding to the desired setting and press [ENTER]/[START] key to save the setting.
Code number
0
1
2
3
[Operation]
The operation is similar to simulation 26-02.
AL-2051 SIMULATION, TROUBLE CODES 10 - 12
Details of function/operation
Setting Display item
OFF
ON
Setting Display item
OFF
ON
Setup
Setting Remark
Setting Display item
0sec 0 SEC.
30sec 30 SEC.
60sec 60 SEC.
90sec 90 SEC.
Remark
Default
Remark
Default (100V series)
Remark
Default