Sharp AL-2051 Service Manual page 90

Main Sub
Contents
code code
26 43 Side void setup
γ life correction setting
54
62 Energy-save mode copy
lamp setup
69 Use to set the operation
conditions for toner near end
[Function]
When this simulation is executed, the currently set code of the side void quantity is displayed
(initial display), and the set data are saved. (Setting range: 0 – 10, Default: 4 (= One side
2.0mm))
Code Setting
0 0 mm
1 0.5 mm
2 1.0 mm
3 1.5 mm
4 2.0 mm
5 2.5 mm
6 3.0 mm
7 3.5 mm
8 4.0 mm
9 4.5 mm
10 5.0 mm
* When the adjustment value is increased by 1, the side void is changed as follows:
Side void adjustment: The side void is increased by 0.5mm. (The side void of "Set value x
0.5mm" is made.)
[Operation]
The operation is similar to simulation 09-04.
[Function]
Used to set the γ life correction.
When this simulation is executed, the current set code number is displayed.
Enter the desired code number and press [ENTER]/[START] key to save the setting.
(Setting range: 0 – 1, default: 1)
Code number
0
1
[Operation]
The operation is similar to simulation 26-02.
[Function]
Used to set half-ON /OFF of the copy lamp in the pre-heat mode.
When this simulation is executed, the current set code number is displayed. Enter the desired
code number and press [ENTER]/[START] key to save the setting.
Code number
0 Copy lamp OFF
1 Copy lamp half-ON
[Operation]
The operation is similar to simulation 26-02.
[Function]
This simulation is used to set the operating conditions for toner near end.
<Toner near end display/No display>
Code number
0 Toner near end is displayed
1 Toner near end is not displayed
<Setting of operations at toner end>
Code number
1 Operation setting 1
2 Operation setting 2
3 Operation setting 3
AL-2051 SIMULATION, TROUBLE CODES 10 - 14
Details of function/operation
Remark
Default
Setting Display item
OFF OFF
ON ON
Setting Display item
OFF
ON
Setting contents
Setting contents
Remark
Default
Remark
Default