Sharp AL-2051 Service Manual page 81

Main Sub
Contents
code code
6 01 Paper feed solenoid ON
02 Resist solenoid ON
7 01 Warm-up display and aging
with jam
06 Intermittent aging
[Function]
When [ENTER]/[START] key is pressed, the selected paper feed solenoid repeats ON for
500ms and OF for 500ms 20times.
When tray select key (or [Numeric] key or [
paper feed solenoid setting is switched.
Code number Setting
0 CPFS1
1 CPFS2
2 MPFS
[Operation]
1) Initial display
06-01 PSOL CHK
0:CPFS1
[Function]
When [ENTER]/[START] key is pressed, the resist solenoid repeats ON for 500ms and OFF for
500ms 20 times.
[Operation]
1) Initial display
06-02 RES.R SOL CHK
EXECUTING...
[Function]
Copying is repeated to make the set quantity of copies.
When the simulation is executed, warm-up is started and warm-up time is added for every sec-
ond from 0 and displayed.
When warm-up is completed, addition is stopped. When [Clear All] key is pressed, the ready
lamp lights up.
After that, enter the copy quantity with [Numeric] key and press [ENTER]/[START] key to repeat
copying of the set quantity (interval 0sec).
To cancel the simulation, turn off the power or execute a simulation which causes hardware
reset.
[Operation]
1) Initial display
07-01 W-UP/AGING
0
[Function]
Copying is repeated to make the set quantity of copies.
When the simulation is executed, warm-up is performed and the ready lamp is lighted.
Enter the copy quantity with the [Numeric] key and press [ENTER]/[START] key, and copying is
executed to make the set quantity of copies, and the ready state is kept for 3sec, and copying is
executed again to make the set quantity of copies. These operations are repeated.
To cancel the simulation, turn off the power or execute a simulation which executes hardware
reset.
[Operation]
1) Initial display (Basic display of copy)
READY TO COPY
100% A4 0
AL-2051 SIMULATION, TROUBLE CODES 10 - 5
Details of function/operation
] [ ] key for the LCD model) is pressed, the
Remark
Operation is possible only when No. 2 cassette is installed.
2) [Numeric] key or [ ] key
06-01 PSOL CHK
1:CPFS2
2) [Numeric] key or [ ] key
06-01 PSOL CHK
2:MPFS
2) After 10sec
07-01 W-UP/AGING
10
3) [ENTER]/[START] key
06-01 PSOL CHK
EXECUTING...
4) Returns to the initial display.