RCA RCD113 Manual

FCC information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
EN
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
In accordance with FCC requirements, changes or modifications not expressly approved by Thomson Consumer Electronics could void the
user's authority to operate this product.
This device generates and uses radio frequency (RF) energy, and if not installed and used properly, this equipment may cause interference
to radio and television reception.
If this equipment does cause interference to radio or television reception (which you can determine by
turning the equipment off and on), try to correct the interference by one or more of the following measures:
• Reorient the receiving antenna (that is, the antenna for the radio or television that is "receiving" the interference).
• Move the unit away from the equipment that is receiving interference.
• Plug the unit into a different wall outlet so that the unit and the equipment receiving interference are on different branch
circuits.
If these measures do not eliminate the interference, please consult your dealer or an experienced
radio/television technician for additional suggestions.
Also, the Federal Communications Commission has prepared a helpful booklet, "How To Identify and Resolve Radio TV Interference Problems."
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402. Please specify stock number 004-000-00345-4
when ordering copies.
This product complies with DHHS Rules 21 CFR Subchapter J. Applicable at the date of manufacture.
For Your Safety
The AC power plug is polarized (one blade is wider than the other) and only fits into AC power outlets one way.
If the plug won't go into the outlet completely, turn the plug over and try to insert it the other way. If it still won't
fit, contact a qualified electrician to change the outlet, or use a different one. Do not attempt to bypass this
safety feature.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

For Your Records

In the event that service should be required, you may need both the model number and the serial number. In the space below, record the
date and place of purchase, and the serial number:
Model No.
Date of Purchase
Place of Purchase
Serial No.
Service Information
This product should be serviced only by those specially trained in appropriate servicing techniques. For instructions on how to obtain service,
refer to the warranty included in this Guide
FOR UNITED KINGDOM VERSION ONLY
RCD113/15/01 EN
CONNECT THE MAIN LEAD INTO A MAINS POWER SOCKET
POWER SUPPLY 230V ~ 50 Hz. It must not be connected to D.C. mains.
Note: The mains lead of the sets is fitted with a moulded plug. If the mains sockets are not compatible or if for
any reason the plug is removed please follow the directions below. The moulded plug cannot be rewired and if
removed must be disposed of safely.
Do NOT under any circumstances plug the severed plug into any mains socket as this could result in electric shock.
Important: If the plug is removed rewire the new plug as follows:
The wires in the mains plug are coloured in accordance with the following code:
BLUE = NEUTRAL / BROWN = LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
BLUE wire to the terminal coded N (Neutral) or coloured black.
BROWN wire to the terminal coded L (Live) or coloured red.
Do NOT make any connection to the terminal in the plug which is marked by the letter E or by the earth symbol
or coloured green or green and yellow.
A fused plug must be fitted with a 3A fuse approved by ASTA or BSI to BS1362 and fuse covers must be always
be securely replaced. If your set does not work, the fuse may be blown.
WARNING:
OR ELECTRICAL SHOCK HAZARD,
DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
1
T H E L I G H T N I N G CAUTION: TO REDUCE THE
FLASH AND ARROW- RISK OF ELECTRIC SHOCK,
HEAD WITHIN THE
D O N O T R E M O V E C O V E R
T R I A N G L E I S A ( O R B A C K ) . N O U S E R -
W A R N I N G S I G N S E RV I C E A B L E PA R T S I N -
ALERTING YOU OF
S I D E . R E F E R S E R V I C I N G
TO PREVENT FIRE
" D A N G E R O U S T O Q U A L I F I E D S E R V I C E
VOLTAGE" INSIDE
PERSONNEL.
THE PRODUCT.
SEE MARKING ON BOTTOM / BACK OF PRODUCT
6/21/01, 3:45 PM
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE EXCLAMATION
POINT WITHIN THE
T R I A N G L E I S A
WARNING SIGN
ALERTING YOU OF
I M P O R T A N T
I N S T R U C T I O N S
A C C O M P A N Y I N G
T H E P R O D U C T .