Components; Electronic; Circulation Pump; Drain Pump - Electrolux Diva Service Manual

3. Components

3.1 Electronic

On electronic models, a micro processor controls all
components, this is done using triacs. The electronic also
memorizes all programme data.
The heating is switched by a relay on the electronic board.

3.2 Circulation Pump

The circulation pump is driven by an asynchronous motor with
an auxiliary winding. The auxiliary winding ist in circuit with a 3
mF capacitor. A tacho generator is used for speed control.
There are three speeds for rinsing.
2800 1/min, 2200 1/min, 1900 1/min, 1700 1/min, 1600 1/min,
Power output 50 W.
Resistances
Main winding 45 - 55 Ohm
Support winding 110 - 140 Ohm
Tacho ca. 220 Ohm

3.3 Drain Pump

The drain pump is driven by a synchronous motor.
Power output 26 W.
Pump rate 15 l/min.

3.4 Flow Heater

The flow heater heats the water to the required temperature.
During the wash cycle, water is contantly passing through the
flow heater.
Power output
Resistor
Protector
Thermal fuse
05.2003 R.K.
2000 W
25 W
98 °C ± 5 K
260 °C
- 2 -
599 517066 EN